Have more questions? Submit a request

Philips Local Firmware Upgrade

  1. Download the Firmware based on the supported device model
  2. Copy the update.zip file in the root folder of a USB flash drive formatted to FAT32
    *NOTE: Do NOT unzip the file!
  3. Turn on the display
  4. Plug the USB flash drive into the device
  5. On the device, press in sequence “HOME, 1, 8, 8, 8” to enter the Admin Mode.
    *NOTE: In the case of BDL4151T and 24BDL4151T, press in sequence the rounded button and the volume down button behind the display
  6. Click “Settings

  1. Based on the device, either select “Signage Display” or “About”, then select “System Updates

  1. If a selection between "Local" and "Remote" comes up, select “Local Update

  1. Select the “update.zip” file from the list and press OK

  1. The device will reboot to perform the update and reboot again once the update is finished
  2. Perform a Factory Reset on the device
  3. Once Factory Reset and the following Initial Setup are finished, check the firmware version on the device in the Settings
Was this article helpful?
0 out of 0 found this helpful